Products

UMFTPD2A

The UMFPD2A debugger/programmer module provides a USB bridge between the FT90x Eclipse IDE development tools runnng on a PC and the FT900 1-wire debug pin. This module can be used to program, configure the EFUSE and debug firmware running on the FT900 device.

  • USB Speed: High Speed (480Mbps), Full Speed (12Mbps)
  • I/O Connector: Debugger interface, 6x1 pin 2.54mm pitch pin connector for UART, 8x1 pin unpopulated 2.54mm pitch vias for GPIO
  • USB Connector: Micro-B USB Device
  • BRT Internal IC: NA

Pack of Single Device:

Buy Now

The UMFPD2A debugger/programmer module provides a USB bridge between the FT90x Eclipse IDE development tools runnng on a PC and the FT900 1-wire debug pin. This module can be used to program, configure the EFUSE and debug firmware running on the FT900 device.

Datasheets
NumberTitleRevisionLast Updated
1DS_MCU-Module_UMFTPD2A1.316 September 2016

Newsletter








    Do not show this pop up again.