What external interfaces does the IDM2040-21R have?

The IDM2040-21R has UART, RS485, I2C and Audio as well as a USB port for firmware upload. 

The UART and RS485 interfaces are controlled by a UART on the RP2040 MCU and are ideal for connecting the module to external systems. For example, in a smart home system, the IDM2040-21R can talk to other smart devices or a system hub over these interfaces. UART is well suited to short connections whilst RS485 uses the same data protocol but allows longer distances (for example 100m).  

The I2C interface is also controlled by the RP2040 and is ideal for interfacing to sensors and other devices. For example, you could use an ambient light sensor or presence detection. Your RP2040 firmware can read the sensor data and control the screen brightness via the FT800’s backlight PWM for optimal brightness and power saving. There are many other use cases too. Note that the connector (CN3 on the board) is not populated by default and is optional, the part number  is BM04B-SRSS-TB. 

The audio connector allows the audio out from the FT800 to be connected to an external speaker. This is an audio level signal and so requires an external amplifier to drive a speaker. Note that the connector (CN6 on the board) is not populated by default and is optional, the part number  is BM04B-SRSS-TB.